You are here:>>XH-W1501
XH-W1501 2017-02-06T12:47:42+00:00

Home › Forums › Any Other Products › XH-W1501

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • Arne Steinarson
    February 6, 2017 at 12:47 pm
    Post count: 0
    #12404 Reply |

    This is my second posting to resolve this problem.

    I purchased the digital thermostat XH-W1501 from Amazon. After installing it (controlling a 12V pump for a wood burning stove), I encountered two problems:

    1 – I cannot enter the menu system. I follow instructions to for example edit “P0”. However the device does not give access to that parameter when I try to enter there.
    2 – Even though the diods indicate that the “cooling relay” is active, the relay itself does not change state.

    Here is my video demonstrating the problem: https://www.youtube.com/watch?v=TQCQnOGlki0&feature=youtu.be

    Please advise.

    Arne S.

    Drok
    Keymaster
    February 7, 2017 at 10:18 am
    Post count: 2971
    #12444 Reply |

    Hello Arne,
    Thank you for writing in.
    Could you please send us the link of product you mention?
    We can’t confirm which item you bought.
    Best regards

    Arne Steinarson
    February 7, 2017 at 12:00 pm
    Post count: 0
    #12448 Reply |

    It is this one:

    https://www.amazon.co.uk/gp/product/B00K8REWYK/ref=oh_aui_detailpage_o01_s00?ie=UTF8&psc=1

    Arne Steinarson
    February 9, 2017 at 1:35 pm
    Post count: 0
    #12558 Reply |

    Any update on this?

    Drok
    Keymaster
    February 13, 2017 at 10:17 am
    Post count: 2971
    #12670 Reply |

    Hello Arne Steinarson,
    We are terribly sorry for response in delay.
    It’s a pity we can’t enter the link you send us.
    We wonder if you have followed the steps below.
    1. Long press the “SET” button for 5 seconds to enter the main menu settings,
    2. press ” + or – ” to switching between P0-P5,then press “SET” to set the value.
    Is that what you have done?
    Best regards.

    Arne Steinarson
    February 14, 2017 at 2:53 pm
    Post count: 0
    #12711 Reply |

    Hello,

    Yes, I press SET for 5 seconds, it shows P0 then. However, on pressing SET again, it just jumps to the temp limit value (it should give me hysteres).

    If I try to go to go to P1 for example: I press SET for 5 seconds, it shows P0 then. I press + to go to P1. But it goes to temp limit value. So I cannot scroll through the menu.

    The last problem is that although the “cold” diod is lit, the cold relay does not appear to flip.

    Best Regards
    Arne S.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
Reply To: XH-W1501
Your information: