I have a particular project need, and I’m wondering if you have any advice about wiring it. I basically have the PAM8403 and I want to use it essentially as a mono amp for three sources and three speakers. I have three piezo mics as sources, and Stereo L/R doesn’t matter at all, and I need to drive three 4Ohm 3w speakers, again stereo doesn’t matter. I don’t know much about Ohms and amplification, but it seems logical that the amp would rather have an equally distributed load. Maybe that’s not the case at all? Is it okay to run two 4Ohm speakers on one channel – say, the left – and one 4Ohm speaker off the right channel? Is there another solution you would recommend?