Problems with Boost Converter 100W/6A 3.5V-30V

Viewing 4 posts - 1 through 4 (of 4 total)

Author

Posts
Matteo Menconi
February 22, 2016 at 4:41 pm

Post count: 0

#3493 Reply |

I recently bought from Amazon your product (Boost Converter).
I wanted to use it to increase 4.2v of my five li-ion battery to 12v.
I connceted all the cables in the right way, the voltmeter begin to measure the voltage:
INPUT 4.2
OUTPUT 4.1
So i turned the potentiometer but the output was still 4.1
I put three batteries in series to have 12.6v and the boost converter gave me 32.8v.
But after 10-15 seconds, the voltage dropped to 12.5v

What could be the problem?

Drok
Keymaster

February 23, 2016 at 1:49 am

Post count: 2971

#3496 Reply |

Hello Matteo,
Thank you for purchasing.
Do you debug the product under a load condition?
If yes, could you please tell us what is the load?
And it is better that you can sent us some photo of the installation.
With your help, we can consult to our technician and find a solution more effectively.
Best regards

Matteo Menconi
February 23, 2016 at 2:18 pm

Post count: 0

#3501 Reply |

I made a video (here), with my bench supply at 4.20v – 9.00v – 12.60v, the load works at 32v 40mA, but it’s only a test.
The real load should be 50w of 12v led strips.

Drok
Keymaster

February 24, 2016 at 2:56 am

Post count: 2971

#3503 Reply |

Hello Matteo,
Thank you for your video and your cooperation.
Basically, the LED strips need to drive by constant current.
But this product is only compatible with constant voltage output but not compatible with constant current output.
If the voltage of the product is boost to 12V, the current will increase suddenly, and then the over-current protection will reduce the output voltage to protect the product.
Therefore, could you please try to change the constant voltage load and apply 3 series batteries as the power supply?
Hope this will be helpful to you.
Best regards
Author

Posts

Viewing 4 posts - 1 through 4 (of 4 total)