You are here:>>Hello, Regarding the VAC9010H.
Hello, Regarding the VAC9010H. 2019-04-18T19:55:05+00:00

Home › Forums › Panel Meter Support › Hello, Regarding the VAC9010H.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Martin Ress
    April 18, 2019 at 7:55 pm
    Post count: 0
    #35792 Reply |

    I have had the unit up and running for a month, the only issue was the fact that the instructions show a J3 connection for relay use and I figured out that a J4 connection is needed.

     

    The device stopped working last night and will not show the display unless I change the jumper from J4 to j3, Is this a blown diode? If so can you tell me the value so I can source it?

    Thanks in advance!

     

    Martin Ress

    Drok
    Keymaster
    April 19, 2019 at 9:11 am
    Post count: 2971
    #35795 Reply |

    Hello Martin Ress，

    Wire jumper is used to switch power supply mode, independent power supply or powered by measuring circuit.

    Could you please kindly take some images to show your connection?

    Best regards.

     

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Hello, Regarding the VAC9010H.
Your information: