You are here:>>Programmable Cycle Relay Module 200088 Timer Issue
Programmable Cycle Relay Module 200088 Timer Issue 2019-06-28T05:23:03+00:00

Home › Forums › Any Other Products › Programmable Cycle Relay Module 200088 Timer Issue

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • Justin
    June 28, 2019 at 5:23 am
    Post count: 0
    #36111 Reply |

    I purchased a programmable timer relay module (PN 200088) on Amazon. All of the functions appear to work as expected; however, the timer is only accurate in modes 17 and 18. In all other modes, T1  and T2 count down extremely fast (9990 = approximately 25 seconds). In some modes, T1 counts down very quickly and T2 counts down very slowly (T2 = 5 = 16 seconds). I have tried all different settings with and without the decimal point and all different modes. Only mode 17 and mode 18 function normally. Any options?

    Thanks for the help,

    Justin

    Drok
    Keymaster
    June 28, 2019 at 9:56 am
    Post count: 2971
    #36117 Reply |

    Hello Justin,

    Thanks for writing in.

    Is it convenient for you to show how it is by video? In that way, we can check it more carefuly.

    You can share us video link or send it to service@droking.com.

    Best regards.

    Justin
    June 28, 2019 at 2:28 pm
    Post count: 0
    #36118 Reply |

    Here’s a link to a video outlining the problem. After more trouble shooting this morning, there appears to be a relationship between programming ending with a “7” or “8” and the issue at hand. Modes 7, 8, 17, and 18 all work normally. Other modes countdown incorrectly.

     

    Drok
    Keymaster
    June 30, 2019 at 7:51 am
    Post count: 2971
    #36128 Reply |

    Hello Justin,

    Thanks for your information.

    After checking, it should be normal. The problem is caused by NX setting.  Please refer to below instruction.

    For mode 7, 8, 17, and 18, NX means the number of cycle.  But for 1-6 and 11-16, it is  a  unit of time.

     

    For example, you want  to set T1 as 10 seconds.  If NX is set as 1 second,  you can set T1 as 10.

    However, if NX is 2, T1 should be  5. The LED  will flash 5 times instead of 10.  It seems the frequency is different, actually time length is the same. You can check the time with other device. For any questions, please kindly contact us.

    Best regards.

     

    • This reply was modified 5 years, 4 months ago by  Drok.
    Brandon
    August 2, 2020 at 4:40 am
    Post count: 0
    #42345 Reply |

    Is there any way to get a datasheet for this product outlining the usage and instructions? Thank you

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
Reply To: Programmable Cycle Relay Module 200088 Timer Issue
Your information: