You are here:>>XY-T01 UART commands (Hysteresis temperature) not working
XY-T01 UART commands (Hysteresis temperature) not working 2021-01-31T03:43:26+00:00

Home › Forums › Any Other Products › XY-T01 UART commands (Hysteresis temperature) not working

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • Yun
    January 31, 2021 at 3:43 am
    Post count: 0
    #58937 Reply |

    I’m testing your XY-T01 temperature controller with PC-serial adapter. All communication works fine except “Hysteresis temperature setting”. I tried B:XX.X, B:XXX, B:XX, B:XXX.X, and many other formats, but all of them does not work.

    Can you let me know the correct command format?

    Thank you.

     

    Drok
    Keymaster
    January 31, 2021 at 7:45 am
    Post count: 2971
    #58954 Reply |

    Hello Yun，

    Could you please tell us how large do you want to set? Can you set it successfuly by buttons?

    Best regards.

    Yun
    January 31, 2021 at 1:19 pm
    Post count: 0
    #58983 Reply |

    The default value is 2.0 C and I’d like to control it at around 2-5.0C. Yes, I can adjust by the buttons on the board, but can’t set via serial. All of my tries returned with Fail message.

    Best regards,

     

    Drok
    Keymaster
    February 1, 2021 at 8:21 am
    Post count: 2971
    #59057 Reply |

    Hello Yun,

    To check further, would you like to show the screenshot about yoru setting？

    You can upload image here or send it to service@droking.com

    Best regards.

    Yun
    February 1, 2021 at 3:17 pm
    Post count: 0
    #59092 Reply |

    I couldn’t figure out how to upload an image file here, so I sent it to your email address.

    The setup is very simple as you see. This temperature controller is connected via USB-serial adapter and I set the serial setting as described in the manual.

    Best regards,

    Drok
    Keymaster
    February 2, 2021 at 3:32 am
    Post count: 2971
    #59145 Reply |

    Hello Yun,

    We received images, but it is regarding connection instead of  setting data. Is it possbiel for you to show that?

    Best regards.

    Yun
    February 2, 2021 at 1:50 pm
    Post count: 0
    #59195 Reply |

    As I replied in the email, I tried various commands like B:025, B:02.5, and similar, but nothing worked.

    If you can let me know the correct command, it would be appreciated.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
Reply To: XY-T01 UART commands (Hysteresis temperature) not working
Your information: