You are here:>>Product required.
Product required. 2016-07-21T19:38:02+00:00

Home › Forums › Advice › Product required.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Maddog
    July 21, 2016 at 7:38 pm
    Post count: 0
    #6565 Reply |

    I have bought dozens of the DROK USB 2.0 Charger Detector Multimeter for testing many USB devices in production and prototyping. I have also bought many of the DROK® DC 3-21V Load Battery Tester, 35W 3A Portable USB Monitor, Intelligent Constant Current Electric Discharge.
    Unfortunately the Load Tester always needs the Multimeter attached to be useful.
    Why don’t you guys build the mulitmeter into the Battery Load so I only have one board?
    You can include the heat sink temperature in the data displayed.
    A very nice addition would be to show the advertised mode and power available from the power source and presented on the D+/D- lines. 500mA/1A/2.1Amp/2.4A (QC 2.0)
    An OLED display would be best for less power and more information available like some of your other products.

    Drok
    Keymaster
    July 22, 2016 at 8:12 am
    Post count: 2971
    #6571 Reply |

    Hello Maddog,
    Thank you for writing in and your valuable suggestion.
    DROK® DC 3-21V Load Battery Tester, 35W 3A Portable USB Monitor, Intelligent Constant Current Electric Discharge Resistance Power Resistor Kit for Power Bank Capacity Testing Support QC2.0/3.0
    We have checked that this product is equipped with a LCD display for you to monitor the values of discharging or charging status.
    The product also has a heat sink and a fan and the temperature of the board is displayed on the LCD monitor.
    Can it meet your need?
    Best regards

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Product required.
Your information: