12V DC Voltage Met…Sensor Probe

[Greg March 4, 2016 at 8:16 pm Post count: 0]

#3560 Reply |

Have just received (3) “X000HR73UH, DROK 12V DC Voltage Met…Sensor Probe LED Display” units. Each unit has three wires, Red, Black and Green, plus a remote wired printed circuit board with two push button switches mounted on them.

Before I hook the meters up, I would like to confirm that the red is +12 VDC, the black is 12 VDC return and the green is earth (ground connected to the black wire).

Also, what is the function of the two push buttons?

[DrokKeymaster March 5, 2016 at 1:27 am Post count: 2971]

#3562 Reply |

Hello Greg,
Thank you for purchasing.
The red wire is connected to the power supply+ (DC 7-30V); the black wire is connected to the power supply- (DC 7-30V) and the green wire is connected to measure voltage+ (DC 0-200V).
The button on the left which is marked “M” is to switch to display time, temperature, voltage.
The button on the right which is marked “S” is for time setting.
Here is the PDF file for the product.Instruction_B00E7OF820
Hope this will be helpful to you.
Best regards

[Greg March 5, 2016 at 11:37 am Post count: 0]

#3564 Reply |

Thanks. That is what I needed.

[DrokKeymaster March 6, 2016 at 3:54 am Post count: 2971]

#3567 Reply |

Hello Greg,
You’re welcome.
If you have any questions, please feel free to write back.
Have a nice day!
Best regards

[Greg March 22, 2016 at 12:22 pm Post count: 0]

#3801 Reply |

I have wired panel meter as per pdf spec sheet. A long press on button “M” causes the display to show “ALL” and then toggles between voltage, time and temperature as per design.

However, button marked “M” does not appear to have any effect as to setting the display to only one mode when quickly depressed.

[DrokKeymaster March 23, 2016 at 3:08 am Post count: 2971]

#3826 Reply |

Hello Greg,
Could you please send us an email to service at droking dot com to send us some photos or video to let us know the problem details?
Thanks

[Author]

Posts