You are here:>>Adjusting Capacity to match battery current state of charge
Adjusting Capacity to match battery current state of charge 2021-11-10T19:16:36+00:00

Home › Forums › Panel Meter Support › Adjusting Capacity to match battery current state of charge

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Randy
    November 10, 2021 at 7:16 pm
    Post count: 0
    #83985 Reply |

    Hello,

    I have the Bi-Directional Meter 100A

    How do I adjust the capacity state meter (battery icon) to reflect the current actual capacity state of my battery?  For example, my battery pack is at 77% capacity but your meter says 100% capacity.

    Thanks

    Drok
    Keymaster
    November 11, 2021 at 7:41 am
    Post count: 2971
    #83998 Reply |

    Hello,

    Please confirm if it is this item,#200219, https://www.amazon.ca/dp/B01MZIAJI0?ref=myi_title_dp

    The capacity percentage =(actual charging or discharging capacity /preset AH value)*100%

    It can only work when you set OAH (over-capacity protection).

    OAH setting: Press button Up or Down  to move yellow cursor to OAH, then hold the OK button to enter parameters setting. After setting, please press OK to save setting.

    Best regards,

    DROK

     

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Adjusting Capacity to match battery current state of charge
Your information: