ammeter won't work?

[Thomas October 10, 2016 at 7:20 am Post count: 0]

#9629 Reply |

So I bought This product from you guys, I have a variable power supply I am creating, I have a 12 V output and a 0 to 30 V output I plug the small black wire into my ground as well as the big black wire, then I put the small red wire into the 12 volt output to power the supply and the small yellow to my positive output. I then put the big red wire in line with my output load. It doesn’t show current and voltage at the same time, and when it shows current it shows a very wrong value I can’t adjust, or just can’t adjust much. Is there a way to fix this so I can show both at the same time.

[Thomas October 10, 2016 at 7:25 am Post count: 0]

#9630 Reply |

I made a picture of what I did to show you if what I typed out was confusing.

[Thomas October 10, 2016 at 7:26 am Post count: 0]

#9631 Reply |

I apparently I used the wrong link this is the picture

[DrokKeymaster October 14, 2016 at 2:15 am Post count: 2971]

#9765 Reply |

Hello Thomas,
Thank you for writing in.
So sorry that we are not sure what you want to use this meter to measure.
Could you please tell us more details of your operation?
And here is the datasheet of the product, please check it.
DATAHSEET_100153
Hope this can help you.
Best regards

[Author]

Posts