You are here:>>Amplifier – connect power
Amplifier – connect power 2016-02-25T05:02:38+00:00

Home › Forums › Any Other Products › Amplifier – connect power

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • Jon Perryman
    February 25, 2016 at 5:02 am
    Post count: 0
    #3508 Reply |

    I ordered the 10w amplifier with with the wire terminals but I received the one with the power socket. Can I solder the power wires to the underside of the board? If so, which pins are the + & -? My guess is that it’s 2 of the three pins (2 directly under socket and 1 to the side). Or am I better off just sending it back to get the one I actually need?

    Thanks, Jon.

    Drok
    Keymaster
    February 25, 2016 at 7:32 am
    Post count: 2971
    #3510 Reply |

    Hello Jon Perryman，
    Thank you for purchasing.
    Could you please tell us your order ID or the ASIN of the product you purchased?
    Thanks

    Jon Perryman
    February 25, 2016 at 2:44 pm
    Post count: 0
    #3512 Reply |

    ASIN B010LKFXVY. My boss orders so much from Amazon that it’s difficult to get an order ID.

    It looks like I received the TYPE_5.5_SOCKET which is a hyperlink from https://www.amazon.com/dp/B010LKFXVY

    Thanks, Jon.

    Drok
    Keymaster
    February 26, 2016 at 2:43 am
    Post count: 2971
    #3518 Reply |

    Hello Jon Perryman,
    Thank you for writing in and your cooperation.
    You can try to solder the power wires to the underside of the board.
    Here is the picture to show you which pin is the +&-:
    Picture_B00C4LB57A
    Hope this will be helpful to you.
    Best regards

    Jon Perryman
    February 26, 2016 at 3:31 pm
    Post count: 0
    #3522 Reply |

    Thank you very much. This will work for me.

    Thanks, Jon.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
Reply To: Amplifier – connect power
Your information: