You are here:>>Boost converter 200310 UART control via Arduino
Boost converter 200310 UART control via Arduino 2022-09-12T01:01:38+00:00

Home Forums Voltage Regulator Support Boost converter 200310 UART control via Arduino

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Mike
    Post count: 0

    Hi All,

    I was hoping to control my boost converter via an Arduino and I’m not having any luck getting the unit to respond.

    I’m using a logic level converter so tx/rx are at 3.3v, and I can tell with a logic analyzer that the messages are going through.  I’ve tried 4800 baud and 9600 baud.

    Any documentation/advice would be amazing.

    Drok
    Keymaster
    Post count: 2971

    Hello Mike,

    Firstly, please notice 200310 is a buck converter, it can’t increase voltage.

    Did you follow this communication protocol? https://www.droking.com/cs/wp-content/uploads/2020/11/200310.pdf

    • This reply was modified 2 years, 3 months ago by  Drok.
Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Boost converter 200310 UART control via Arduino
Your information: