I somehow hit a combination of buttons that took me into the calibration settings and not knowing what I was doing proceeded to mess things up. Well making mistakes and messing things up is a good teacher, as I now know much more about this meter than I did. I read through the few posts on the forum about calibrating this meter as none of this info is in the directions. But the step by step at the end of the post for the amp draw for charge and discharge is greatly lacking. I can take it through word for word step by step button by button and it doesn’t work. i seem to have got it reading fairly close but to tell you the truth I don’t really know how LOL. If we could get a new clearer step by step instructional I would greatly appreciate it.
couple problems/ questions I had 1. Setting the amp draw wasn’t a problem it was getting it to zero seems like I did it in the “OUT” spot, not the menu. 2. How did I ever get into the calibration menu in the first place as I can only get into it now with the power connector and cannot for the life of me get into it again without cycling power 3. Is there a way to get in and out or just out after running the curser down to save hitting OK then nothing you can never get out until you cycle power. 4. I notice the counter that runs when I am setting the amps and voltage seems to have a buffer between say a tenth of a volt and another or say between .5 amp and zero can I assume this would basically be the next decimal spot. say its 200 between .5 and .6 at 100 would be .55.
Am sure some of these questions will be obvious with a good set of instructions or with me accidentally resetting it a few more times. Thanks
rich
Post count: 0