DROK 090433 L298N Motor Drive Controller Board

[Thomas December 3, 2016 at 12:28 am Post count: 0]

#10940 Reply |

Where do I find the pin out and data for the board

[DrokKeymaster December 4, 2016 at 3:24 am Post count: 2971]

#10964 Reply |

Hello Thomas,
Thank you for writing in.
Here the PDF file is the datasheet of the product, please check it.
DATASHEET_090433
Hope this can help you.
Best regards

[mick December 23, 2016 at 3:48 am Post count: 0]

#11220 Reply |

I just purchased your L298N Motor Drive Controller Board. Looking down from the top, the voltage connectors are labeled left to right +12v/gnd/+5v (then the ENA and IN1-IN4 and ENB). The datasheet shows it reversed – left to right +5v/grn/+12v. I’m guessing the data sheet is correct and the silkscreen labeling on the bottom of my board was printed upside down.
I hope you can clear this up.
-Mick

[DrokKeymaster December 23, 2016 at 10:41 am Post count: 2971]

#11227 Reply |

Dear mick,
We are sorry for any inconvenience caused you.
Yes, the data sheet is right.
The “+12V” is near “A Enable”.
Hope this can be helpful.
Best regards

[George July 25, 2017 at 12:13 am Post count: 0]

#19825 Reply |

I purchased the L298N motor drive controller board because the description on Amazon.com says it can handle drive voltage up to 35V. I need to drive only one motor. Where can put 35V into the device to drive the motor? Should I use the +12V screw terminal (near “A-Enable)? Thank you for helping.

[DrokKeymaster July 26, 2017 at 9:05 am Post count: 2971]

#19842 Reply |

Hello George,
Thanks for writing in.
Are you talking about this item?
090433
Yes, you can input 35V drive voltage to +12V power terminal (near “A-Enable). The +5V terminal is logic input.

For any more questions, please fee free to contact us.
Best regards.

[Author]

Posts