Drok Panel Meter 200139 – Set Voltage Alarm Threshold

[Duane M Reese August 28, 2018 at 4:55 pm Post count: 0]

#30195 Reply |

When I go to set this threshold, there are tow voltages shown, one on the left and one on the right.

If I want a voltage alarm at 12.8 Vdc, haow should I set these two voltages??

Thanks,

 

Duane

 

[DrokKeymaster August 29, 2018 at 9:35 am Post count: 2971]

#30198 Reply |

Hello Duane M Reese,

Thanks for writing in.

The left one is high voltage alarm, the right one is low votlage alarm.

From hight voltage value to low voltage value, there are 6 digits of number, you can short press button to increase them. Without button operation  for over 3 seconds, it will switch to next digit.

After setting, please keep pressing button until it show” PASS”.

Hope this can help you.

Best regards.

[Author]

Posts