Found this on Amazon.com. Is it from your company? I want to buy, but need to know how to use with RC. Is it only able to be used with microcontrollers?
Hello John,
Thank you for writing in.
As long as the signal of the device is PWM signal, it can be used with both RC and micro-controller.
Hope this can help you.
Best regards
Re; Smart Car DC Dual Motor Driver PWM Module Circuit Board H-bridge MOSFET Driver
I have been thinking of using this driver but cannot find any real information on the input. Everything I find leaves me wondering
Example:
Motor forward: DIR = 1 PWM = PWM
Motor reversal: DIR = 0 PWM = PWM
Parking brake: DIR = X PWM = 0 (X is an arbitrary state)
Is this telling me:
Set dir. to “1” and send the PWM signal in PWM 1
Interested in this driver:
Smart Car DC Dual Motor Driver PWM Module Circuit Board H-bridge MOSFET Driver
Not sure what I’m connecting here:
EXAMPLE: (from site info)
Motor forward: DIR = 1 PWM = PWM
Motor reversal: DIR = 0 PWM = PWM
Parking brake: DIR = X PWM = 0 (X is an arbitrary state)
Is this telling me to Place DIR-1 to a high (1) and supply PWM-1 pin with the PWM?
to reverse Set DIR-1 to a Low (0)
to break just set a low on PWM
To use 2 motors I would setup DIR 2 & PWM 2 accordingly?
Hello john R.,
Thank you for writing in.
Yes, your thought is right.
Motor forward: place DIR-1 to high voltage signal(1) and supply PWM-1 with PWM signal.
Motor reversal: place DIR-1 to low voltage signal(0).
Parking brake: place a low on PWM.
If you use 2 motors, you can setup DIR-2 and PWM-2.
Hope this can help you.
Best regards
John
john R.