You are here:>>How to wire 200219 voltmeter to shut off load using relay and switch?
How to wire 200219 voltmeter to shut off load using relay and switch? 2020-06-27T06:08:09+00:00

Home › Forums › Advice › How to wire 200219 voltmeter to shut off load using relay and switch?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Joe Adkins
    June 27, 2020 at 6:08 am
    Post count: 0
    #40139 Reply |

    Looking at the instruction manual for 200219 voltmeter, I wasn’t sure how to wire in a switch to shut off load using a switch/relay?   I found someone else on this forum that had this drawn up, but wasn’t sure if this would shut off the inverter with my switch?

    Again, I want to use a 2pole switch to shut off the inverter, leaving the 200219 powered on.  Will this configuration work in this way?200219 wiring with relay and switch

    Drok
    Keymaster
    June 28, 2020 at 9:46 am
    Post count: 2971
    #40197 Reply |

    Hello Joe Adkins,

    “-Vext+”  is independent power  port for item. If you want to leave item on, please connect independent power supply for it.  Now your switch is to control the power to our item instead of inverter.

    “-Relay+” is connected to relay. If you are not going to connect relay, please ignore it. It can’t accept  pwoer input. Once your connect power to “”- Vext+“， relay can be powered on. ” It seems your  connection on “-Relay+” is conflict.

    Please refer to Image1-3  in our insruction.

    https://images-na.ssl-images-amazon.com/images/I/D1xd3n-y-DS.pdf

    Best regards.

     

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: How to wire 200219 voltmeter to shut off load using relay and switch?
Your information: