You are here:>>Installation wiring perameters
Installation wiring perameters 2022-05-13T23:22:40+00:00

Home › Forums › Advice › Installation wiring perameters

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • Joseph DeVecchio
    May 13, 2022 at 11:22 pm
    Post count: 0
    #92925 Reply |

    I just received the Drok JS-C33 Battery Capacity Voltage meter (SKU:200171003) which I purchased on Amazon. I need additional information to be able to install it for it’s intended purpose.

    * Can the wires in the harness provided with the meter be extended?

    * What size conductors should be used and is there a maximum length?

    * I have 6 batteries connected in series to provide the power needed for a golf cart I want to meter. Where should the temperature sensor be mounted on this battery bank and what is an approved method of attachment?

    Thank You.

    Drok
    Keymaster
    May 15, 2022 at 10:03 am
    Post count: 2971
    #93003 Reply |

    Hello Joseph DeVecchio,

    You can extend lead wire as need, it doesn’t affect measurement. If you want to monitor the battery temperature, just put the sensor close to battery.

    Best regards.

    TOM
    October 2, 2023 at 4:21 pm
    Post count: 0
    #117228 Reply |

    I have model JS-C33 battery power display, I have a single 48v lithium iron battery on a golf cart I set battery type to F15

    the display show 100% charge all the time even after using golf cart for extended periods of time. Is this setting correct if so what do i need to change to get accurate reading?

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
Reply To: Installation wiring perameters
Your information: