You are here:>>multiple 200310 on one serial controller using communication adress code setting
multiple 200310 on one serial controller using communication adress code setting 2022-09-11T08:45:34+00:00

Home › Forums › Advice › multiple 200310 on one serial controller using communication adress code setting

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • mounty
    September 11, 2022 at 8:45 am
    Post count: 0
    #101057 Reply |

    Hi,

    I have 6 pieces 200310 and would like to control them with one serial controller.

    Is it possible to connect all uart cables (T, G, R, V) parallel?

    In the instruction manual under 9. it is possible to set the communication address 1-26 (a-z).

    How is the correct command from the controller to address the single modules?

     

    Kind regards

    Frank

    Drok
    Keymaster
    September 15, 2022 at 3:31 am
    Post count: 2971
    #101390 Reply |

    Hello mounty,

    Parallel connection is not available. And address 1-26 just save output setting parameters.

    Best regards.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: multiple 200310 on one serial controller using communication adress code setting
Your information: