need wiring diagram

[Terry E Rickards May 16, 2016 at 4:33 pm Post count: 0]

#4966 Reply |

Hi, I need a basic wiring diagram for my rv install. I have a Renogy solar panel system,
with charging regulator charging on board batteries. solar in ( + and -)
batteries out ( + and – ). The meter is your Mutimeter 6.5-100v 100a/75mv w/ext shunt
Thank you for your help.

[DrokKeymaster May 17, 2016 at 3:04 am Post count: 2971]

#4977 Reply |

Hi Terry E,
Thank you for writing in.
Here is the wiring diagram for you:

Hope this can help you.
Best regards

[Terry E Rickards May 17, 2016 at 9:12 pm Post count: 0]

#4986 Reply |

Thanks for the diagram. Still unsure on some locations.is the dc load location “my battery”. And is the dc power supply to be considered my solar in (+ -) or the battery out + – on my charge controller. Please be specific this is my first project of this type. Thanks again for your help.

[DrokKeymaster May 18, 2016 at 2:35 am Post count: 2971]

#4990 Reply |

Hi Terry E,
The wiring diagram we sent to you previous is used to measure the voltage, current, power, capacity of the load.
We are not sure what you would like to apply the meter to text in your application, the output of your solar panel or the charging condition of the battery?
Could you please tell us where you would like to text?
You can also send us an image of the diagram of your application you plan to, so that we can check it if it can work.
And there is also a wiring diagram in Wiring diagram in the backside of the meter for reference.

Hope this can help you.
Best regards

[Author]

Posts