You are here:>>Stuck at calibration screen
Stuck at calibration screen 2021-10-11T18:56:09+00:00

Home › Forums › Advice › Stuck at calibration screen

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Gary Price
    October 11, 2021 at 6:56 pm
    Post count: 0
    #82482 Reply |

    DROK 48v Battery Meter, 10-100v Marine RV Battery Capacity Volt Monitor 12v 24v, Lithium Battery Voltage Fahrenheit Temp Indicator Gauge

     

    I bought this and it is stuck at calibration screen. I try long press power button, long press setup button, I try long press both buttons. Still stuck reading 20.0 50.3v

    p.s.  I hit extra long press (10 seconds) and it goes to main screen but then defaults back to calibration screen.  Instructions say to get to 20v but I don’t have anything that’s 20v.

    Drok
    Keymaster
    October 12, 2021 at 8:02 am
    Post count: 2971
    #82537 Reply |

    Hello,

    Unless  there is large error on voltage reading, it is not necessary to calibrate reading each time.

    In generla, you just need to hold the button to exit  calibration setup. If it can’t work, please disconnect power supply and power on again.

    Best regards.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Stuck at calibration screen
Your information: