You are here:>>USB Tester Capacity clears each time ??
USB Tester Capacity clears each time ?? 2016-05-01T13:56:47+00:00

Home › Forums › Advice › USB Tester Capacity clears each time ??

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • Victor Z
    May 1, 2016 at 1:56 pm
    Post count: 0
    #4754 Reply |

    I have the USB multimeter/tester and it is a great device. Thank you!

    I would like to be able to read the total capacity of my USB portable charger battery. I see the display shows the mA/H reading. When my device is full, I disconnect the tester. When I connect it again, it shows the previous mA/H reading, flashes twice, and starts from zero again. I know I can manually clear the reading by holding the button … but how do I keep it from clearing each time automatically?

    Thank you for your reply,
    Victor

    Drok
    Keymaster
    May 7, 2016 at 2:47 am
    Post count: 2971
    #4806 Reply |

    Hello Victor Z,
    Thank you for writing in.
    Could you please tell us your order ID or the link of the product?
    Thanks

    Victor Z
    May 19, 2016 at 8:16 pm
    Post count: 0
    #5016 Reply |

    Thanks for your reply. Sorry for the delay on my end in answering your question … I was away for the past week or so.

    DROK USB 2.0 Digital Multimeter…

    Drok
    Keymaster
    May 20, 2016 at 4:00 am
    Post count: 2971
    #5023 Reply |

    Hi Victor Z,
    If you want the product do not clear data automatically when it power on again, you should not connect a load to the product, then the capacity will not be clear and you can use the button to check the previous test results.
    But if you connect a load to the product, the capacity will be cleared.
    Hope this can help you.
    Best regards

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
Reply To: USB Tester Capacity clears each time ??
Your information: