You are here:>>Using Steup Up for 24v Power Supply for Printer
Using Steup Up for 24v Power Supply for Printer 2016-06-28T22:38:15+00:00

Home › Forums › Advice › Using Steup Up for 24v Power Supply for Printer

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • Erik
    June 28, 2016 at 10:38 pm
    Post count: 0
    #5982 Reply |

    We have a printer we’d like to use on a harvester (12v) that needs 24v at about 2.5 amps. We bought this device from drok and connected it to the 12v output on the harvester. Then we connected a meter and adjusted the drok until we had 24v output. Then we hooked up the printer. The printer would not power up and we blew a fuse.

    Any thoughts on where we might be going wrong?

    Thanks for your help.

    Erik

    Drok
    Keymaster
    June 29, 2016 at 6:21 am
    Post count: 2971
    #5989 Reply |

    Hello Erik,
    Thank you for writing in.
    Is the output voltage of the product is 24V when without connecting the printer?
    Have you checked that if there is reverse connected of the positive and negative sides?
    It is better that you can send us some images of your wiring to let us check the problem details.
    You can send the images and the information by email (service at droking dot com)
    With your help, we can find a solution more quickly.
    Looking forward to hearing from you.
    Best regards

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
Reply To: Using Steup Up for 24v Power Supply for Printer
Your information: