Anyone can tell me that what are three readings on this meter maenad: one is at upright corner(show AH), second one is at bottom right corner(shown W) and third is at left bottom corner(also shown W). Also there were + and – signs associated with it. There was a “battery bar” at upper left corner, how it can be programmed to reflex real capacity. Thanks.
on my WLS-PVA200 I reset the current and with no flow (nothing going through the loop) it shows .02, shouldn’t it be “0”? When I put the load in it does show a reading however it is not accurate, it reads very low. I put a Fluke ammeter on to check it. for example the fluke shows .8 and the DROK shows .4. as the actual load increases the difference increases.
chung nieh
Dave Williams
Bob