XY-T01 UART commands (Hysteresis temperature) not working

[Yun January 31, 2021 at 3:43 am Post count: 0]

#58937 Reply |

I’m testing your XY-T01 temperature controller with PC-serial adapter. All communication works fine except “Hysteresis temperature setting”. I tried B:XX.X, B:XXX, B:XX, B:XXX.X, and many other formats, but all of them does not work.

Can you let me know the correct command format?

Thank you.

 

[DrokKeymaster January 31, 2021 at 7:45 am Post count: 2971]

#58954 Reply |

Hello Yun，

Could you please tell us how large do you want to set? Can you set it successfuly by buttons?

Best regards.

[Yun January 31, 2021 at 1:19 pm Post count: 0]

#58983 Reply |

The default value is 2.0 C and I’d like to control it at around 2-5.0C. Yes, I can adjust by the buttons on the board, but can’t set via serial. All of my tries returned with Fail message.

Best regards,

 

[DrokKeymaster February 1, 2021 at 8:21 am Post count: 2971]

#59057 Reply |

Hello Yun,

To check further, would you like to show the screenshot about yoru setting？

You can upload image here or send it to service@droking.com

Best regards.

[Yun February 1, 2021 at 3:17 pm Post count: 0]

#59092 Reply |

I couldn’t figure out how to upload an image file here, so I sent it to your email address.

The setup is very simple as you see. This temperature controller is connected via USB-serial adapter and I set the serial setting as described in the manual.

Best regards,

[DrokKeymaster February 2, 2021 at 3:32 am Post count: 2971]

#59145 Reply |

Hello Yun,

We received images, but it is regarding connection instead of  setting data. Is it possbiel for you to show that?

Best regards.

[Yun February 2, 2021 at 1:50 pm Post count: 0]

#59195 Reply |

As I replied in the email, I tried various commands like B:025, B:02.5, and similar, but nothing worked.

If you can let me know the correct command, it would be appreciated.

[Author]

Posts